chip-conveyor-magnetism-scraper-1

Magnetic Scraper

A magnet is installed on the bottom of the conveyor belt to attract the chips in the cutting fluid to the conveyor belt. The chips are affixed to the belt and are unable to flow with the cutting fluid. The scraper bars then scrape the chips off the bottom of the chip conveyor for further filtration processing.

Suitable Chips

For short and fine magnetic metal chips smaller than 75mm.

Types
Magnetic Scraper Chip Conveyor
  • Head conforms to CE safety regulations
  • Uses a horizontal motor
  • Head conforms to CE safety regulations
  • Uses a hollow shaft motor
  • Head conforms to CE safety regulations
  • Uses a hollow shaft motor
  • Head conforms to CE safety regulations
  • Uses a horizontal motor
  • Head conforms to CE safety regulations
  • Uses a hollow shaft motor
Features
  • Adsorption capacity up to 100mm high; effective adsorption of chips in the cutting fluid.

  • Variety of scraping widths provide ample matching flexibility.

  • Integrated design of the water tank with the chip conveyor eliminates the need to clean up the water tank.

  • Chip discharge and drainage design reduces the water content of the filtered chips.

  • Equipped with a torque limiter to prevent damage caused by improper operation.

  • CE certification guarantees safe operation.

Specification
  • 0.03~0.07m³/hr
  • Less than 15m
Belt Specification
Belt Pitch(P)
(mm)
Belt Width(W)
(mm)
31.75 W150 W175 W200 W250 W300 W350 W400 W450 W500
38.1 W150 W175 W200 W250 W300 W350 W400 W450 W500
 

KEYARROW

Safeguarding Armor
Purifying Forest